Is Your Thermostat Malfunctioning? Reasons You’re Having Problems with Your Heating and Cooling in Albany, OR

January 20, 2017 2:45 am Published by Leave your thoughts

When your HVAC system clicks on and off to often, or it won’t start up or turn off, or only some rooms in your house are receiving air, then you must take the time to figure out what’s causing the problem. But before you panic because you think something is the matter with your furnace or air conditioner, check the thermostat. A thermostat that is not properly cared for can give the impression that your heating and cooling in Albany, OR is malfunctioning when, in fact, it’s not. Let’s look at a few of the most common reasons for thermostat problems.

Placed in a bad location

Like your home smoke detectors, your thermostat will work best when placed in a location where it won’t prematurely activate. In other words, put a smoke alarm in the kitchen where there’s smoke from cooking and it will sound off, and put a thermostat near a heat or cold source—like a television, lamp, drafty window or exterior door—and it is likely to go bonkers. Although your thermostat may be working right, the fact that it’s sending the wrong commands to the furnace or air conditioner can make you think it’s broken.

Needs new batteries

Today’s thermostats are pretty high tech. Some talk to you, some have convenient keypad attachments and others display all sorts of internal temperature information on a digital electric faceplate. Remember that both newer and older thermostats run on batteries, which need replacing every now and then so the thermostat can do its job. All too often, residential and commercial HVAC repair shops answer frantic calls that turn out to be problems associated with dead or near-dead thermostat batteries. Check them and change them to avoid unnecessary panic.

It’s dirty

Older mechanical thermostats tend to get dirtier than newer devices because they house big buttons, levers or switches used to set the temperature up or down. These pieces can easily collect dirt, dust and small airborne debris underneath them to make it seem as though your heating and cooling in Albany, OR is malfunctioning when, in reality, it’s just a problem with a dirty thermostat. First, try cleaning around and in between the switches, followed by carefully taking off the cover to remove debris from the inside. Use a soft brush to do this.

The bottom line is that a faulty thermostat that is not dealt with can cause all sorts of HVAC related problems—like the heater or air conditioner not starting or stopping, or uneven temperature distribution. But oftentimes, problems can be avoided when homeowners are armed with knowledge. Take the time to learn how to program your specific thermostat, and remember to change the batteries at least once a year. At Larsell Mechanical Service, we can teach you the proper way to use your thermostat after new HVAC installation, and beyond!

If problems still persist after you change the thermostat batteries, give the professional HVAC team at Larsell Mechanical Service a call. We can assess and determine whether the issue with your heating and cooling in Albany, OR is due to a malfunctioning thermostat or something more serious.

Categorised in:

This post was written by Writer

Leave a Reply

Your email address will not be published. Required fields are marked *